Master Spas H2X Manuel du propriétaire télécharger pdf (Page 17)

Do Not Dive.

INSTALLATION INSTRUCTIONS

1.) Put swim spa in final position that allows for access to equipment and swim

spa components.

2.) Remove front side panel (This is the side where the main topside control

panel is located) so electrical can be hooked up to the swim spa system pack.

3.) Be sure all pump and heater unions are secure. Each pump has 2 unions and

the heater has 2 unions. A newly delivered swim spa may have loose unions

caused in transporting the swim spa. Check that all slice valves are open,

in the up position. Again, the slice valves may become closed during trans

portation of the swim spa.

4.) Fill swim spa to the "minimum safe water level" sticker.We recommend

filling the swim spa through the filter area.

5.) Turn the power on to the swim spa. The swim spa will go through its priming

mode.This lasts approximately 5 minutes.

6.) Be sure the jets in your swim spa are open.

Removing of Panels

Slice Valve

and Pump Union

07MS H2X Owners Manual 1/10/07 11:29 PM Page 17

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 45 46

Pas de commentaire

Master Spas H2X Manuel du propriétaire Page 17