Master Spas H2X Manuel du propriétaire télécharger pdf (Page 18)

Do Not Dive.

INSTALLATION INSTRUCTIONS

7.) It may be necessary to bleed air from the motor(s) on your swim spa if,

after start up, your swim spa pumps do not operate.

Due to the nature of water flow and hydro-therapy pumps, please be advised

that air locking of pumps may occur. Master Spas has taken measures to

reduce the possibility of this, but it still may occur, especially after refilling a

swim spa. This is not a service covered under warranty.

To relieve an airlock situation, loosen the pump union (see picture) on the

discharge of the pump (the end of the pump that water is being pushed

through). Water should leak out. Tighten the union and test the pump for

proper jet flow. If needed repeat process.

*NOTE: Upon power up, the propulsion system may cavitate or mix water with

air for up to several minutes until all of the air is pulled from the

propulsion chamber.Your propulsion system may be noisy during this

time.This is normal.

8.) Adjust water chemistry according to the instructions provided in the

"Swim Spa Water Quality Maintenance" Section. (page 21).

9.) Your swim spa water will heat approximately 1° - 2° per hour,

on average.Times may vary.

Airlock

Pump Union

Slice Valve

07MS H2X Owners Manual 1/10/07 11:29 PM Page 18

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 45 46

Pas de commentaire

Master Spas H2X Manuel du propriétaire Page 18